Hi Everybody, I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data. Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them? Thanks in advance. :) Kind Regards, Dennis Ebben
Sorry Alberto, I was read over your e-mail account. Driver I mailed to you. Check your account. Stefan
Dear Stefan and Friends, I am also working on an I2C – EEPROM(FM24C256) application for XC167, so far I have used Dave generated code but I got into trouble. Writing works fine but reading…not. Stefan, is it possible for me to share your I2C code? My e-mail address is ai(at)home.se With best regards, Atsushi Ishii
Hi Stefan and freinds, I am using the iiC module of the XC161 to communicate to external eeprom. Please can i share you iic files? email:kaleem20@yahoo.com Thanks in advance Kaleem.
Hi Stefan! I'm also working with a XC161 and i didn't get my routines working. Can you please send me the routines. Thank you in advance. email: tinytove@gmx.at
Hi Ludwig, I sent it. Sorry for delay. Stefan
Hello Stefan, i have the same problem XC167 with 24LC16B serial eeprom. would you please send me the routines? Thomas
Hi Thomas, that is no problem, but I need your e-mail address to send it. Best regards - Stefan
Hello Stefan, my email address is thomas.schneider@berger-lahr.com thank you Thomas
Hi Thomas - done !! Stefan
Hi Stefan, could you (or someone who have also the code) please send me IIC-code? best regards, Karl E-Mail:koarl70(at)gmx.at
Hello Stefan: I'm working with XC167CI and want to change my bit banging routines from C 167 CS to the new hardware IIC Module. Reading the treads about this theme, I want to ask you if you could please send me the routines to use the IIC hardware. Thanks a lot! christian.winkler@winkler-urach.de Christian
Hi Karl, hi Christian, Do it in some minutes. Sorry for delay, I was on vacation. Stefan
Stefan, is it possible to share your I2C code? My e-mail address is georg(at)eunet.yu With best regards, Gyoergy Dozsa
I'm working on a Multimaster-system with 2 xc167 connected via i2c bus and i think i have a timing problem becouse the system is not very stable. If anybody got a working multimastersystem it would be nice to share some code with me. Thanks peter.scheuermann@ies-systems.com
Dear Stefan as many others I have problems to get the I2C routines on the XC161CS-32F working. I would appreciate if you could share your code. My email:dhandzic@plantron.se
Hello Dirk, I sent it, please check your account. Stefan