We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi Everybody, I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data. Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them? Thanks in advance. :) Kind Regards, Dennis Ebben
Hello Stefan: I'm working with XC167CI and want to change my bit banging routines from C 167 CS to the new hardware IIC Module. Reading the treads about this theme, I want to ask you if you could please send me the routines to use the IIC hardware. Thanks a lot! christian.winkler@winkler-urach.de Christian
Hi Karl, hi Christian, Do it in some minutes. Sorry for delay, I was on vacation. Stefan
Stefan, is it possible to share your I2C code? My e-mail address is georg(at)eunet.yu With best regards, Gyoergy Dozsa
I'm working on a Multimaster-system with 2 xc167 connected via i2c bus and i think i have a timing problem becouse the system is not very stable. If anybody got a working multimastersystem it would be nice to share some code with me. Thanks peter.scheuermann@ies-systems.com
Dear Stefan as many others I have problems to get the I2C routines on the XC161CS-32F working. I would appreciate if you could share your code. My email:dhandzic@plantron.se
Hello Dirk, I sent it, please check your account. Stefan
Really nice to see that this topic is still interesting for a lot of people. :)
Hallo Stefan, Könntest Du mir den Low-Level-Treiber von Infineon auch zukommen lassen. Habe auch Probleme den I2C-Bus ans laufen zu bekommen. Email: m.stahl@moba.de Danke im vorraus. Dear Stefan could you share your code. I have also some problems with the i2c-routines. email: m.stahl@moba.de Best regards
Hi Michael, I sent it. With german remarks ;-). Check your account. Stefan
hello, i'm working with xc167 an also had many problems with i2c. is it possible to share your code an send it to me? thanks a lot. e-mail: mo@mimot.de michael
Hi Michael, done.
Hi Stefan, although this thread is over 18 months old now, today I experienced exactly the same problems while implementing a serial eeprom driver. So, may I humbly ask you for your routines too? Thank you very much in advance. My email is uwe.roth@web.de Uwe
Hi Uwe, the routines are based on the hardware implemented I2C module of XC16x devices. So I am not sure, whether they would be usefull to you. If you want them still, however, I see no problem to mail them to you. Let me know Stefan
Yes, of course. I'm using (i.e. I'm trying to use) the IIC of a XC161CJ (in polling mode). Using the Pins of P9 with a software emulated I2C Bus would be an alternative, but I'd like to avoid this. Uwe
Hi Uwe, sorry for delay, I will mail it in some minutes. Good luck, Stefan
You may also find this useful: http://www.keil.com/download/docs/xc16x_i2c_ex.zip.asp