We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi Everybody, I'm experimenting with Infineon's XC161CJ-controller on an Infineon SK-XC16x starter kit. Most of my routines work now, except the I2C-routines. Sending of data works OK, but the errors occur when I want to receive data. Has anybody on this forum written I2C-routines for this controller? And if so, are you willing to share them? Thanks in advance. :) Kind Regards, Dennis Ebben
Hi Alberto, no problem. Leave your e-mail here, I will send you asap. Stefan
Sorry Alberto, I was read over your e-mail account. Driver I mailed to you. Check your account. Stefan
Dear Stefan and Friends, I am also working on an I2C – EEPROM(FM24C256) application for XC167, so far I have used Dave generated code but I got into trouble. Writing works fine but reading…not. Stefan, is it possible for me to share your I2C code? My e-mail address is ai(at)home.se With best regards, Atsushi Ishii
Hi Stefan and freinds, I am using the iiC module of the XC161 to communicate to external eeprom. Please can i share you iic files? email:kaleem20@yahoo.com Thanks in advance Kaleem.
Hi Stefan! I'm also working with a XC161 and i didn't get my routines working. Can you please send me the routines. Thank you in advance. email: tinytove@gmx.at
Hi Ludwig, I sent it. Sorry for delay. Stefan
Hello Stefan, i have the same problem XC167 with 24LC16B serial eeprom. would you please send me the routines? Thomas
Hi Thomas, that is no problem, but I need your e-mail address to send it. Best regards - Stefan
Hello Stefan, my email address is thomas.schneider@berger-lahr.com thank you Thomas
Hi Thomas - done !! Stefan
Hi Stefan, could you (or someone who have also the code) please send me IIC-code? best regards, Karl E-Mail:koarl70(at)gmx.at
Hello Stefan: I'm working with XC167CI and want to change my bit banging routines from C 167 CS to the new hardware IIC Module. Reading the treads about this theme, I want to ask you if you could please send me the routines to use the IIC hardware. Thanks a lot! christian.winkler@winkler-urach.de Christian
Hi Karl, hi Christian, Do it in some minutes. Sorry for delay, I was on vacation. Stefan
Stefan, is it possible to share your I2C code? My e-mail address is georg(at)eunet.yu With best regards, Gyoergy Dozsa
I'm working on a Multimaster-system with 2 xc167 connected via i2c bus and i think i have a timing problem becouse the system is not very stable. If anybody got a working multimastersystem it would be nice to share some code with me. Thanks peter.scheuermann@ies-systems.com
Dear Stefan as many others I have problems to get the I2C routines on the XC161CS-32F working. I would appreciate if you could share your code. My email:dhandzic@plantron.se