Keil forum Full Chip Erase Failed

State Suggested Answer
Locked Locked
Replies 4 replies
Answers 1 answer
Subscribers 20 subscribers
Views 1057 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Full Chip Erase Failed

Pradeep V 9 months ago

I'm using Keil uVision for MDK v5.39 with Segger J-Link and trying to debug MCU from GigaDevice (part #GD32F303CB).

I'm getting "Full Chip Erase Failed" error and not able to proceed. What are the possible reason for this error?

Top replies

Andreas Barth 9 months ago +1 suggested

Maybe a problem in the Flash Programming Algorithm in use. As these are supplied by GigaDevice in their GD32F30x_DFP without source, please contact them about this issue.

Parents

0 Andreas Barth 9 months ago

Maybe a problem in the Flash Programming Algorithm in use. As these are supplied by GigaDevice in their GD32F30x_DFP without source, please contact them about this issue.
Cancel
Up +1 Down

Cancel

Reply

0 Andreas Barth 9 months ago

Maybe a problem in the Flash Programming Algorithm in use. As these are supplied by GigaDevice in their GD32F30x_DFP without source, please contact them about this issue.
Cancel
Up +1 Down

Cancel

Children

0 Pradeep V 9 months ago in reply to Andreas Barth

Thanks Andreas for the suggestion, i'll check with the supplier.
Cancel
Up 0 Down

Cancel