This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

STM32H745 dual core debugging using Keil and ULINK2

Hello,

We are working on a project using STM32745 and we are able to successfully flash both cores (m7 and m4) using Keil and ULINK2 and run it.

But now we are at a stage where we need to debug some of the code. So far I have not found any document on how to debug dual core using Keil and ULINK2.

Can you please point us to the right direction.

Top replies

Hans Schneebauer over 2 years ago in reply to Hemant Kapoor +3 verified

Please also see our application note 338 step 6 on page 8: https://developer.arm.com/documentation/kan338/1-0/?lang=en The most important sentence for you in this chapter is: -------------------...
rkopsch over 2 years ago +1 verified

See: Multi-Core Debugging with MDK (arm.com) That link also confirms "The ULINKpro and ULINKplus adapters provide the best performance and support interrupt handling and timing display." Related...

Parents

0 Stephen Theobald over 2 years ago

Moved to the Keil forum
Cancel
Up 0 Down

Cancel

Reply

0 Stephen Theobald over 2 years ago

Moved to the Keil forum
Cancel
Up 0 Down

Cancel

Children

No data