Debug mode cursor doesn't show in C code file Hi,everyone, When i use ST-Link Debugger to debug code,the current cursor show in disassembly code windows. I want to set cursor show in c code file,what should i do?
i configure Options->Load Application at Startup and Debug Run to main()
Any idea how to do? Thanks
Is the USART1 reference a typo?
It gets stuck in this loop? Or doesn't get there?
If it is not getting to this loop, then pay attention to where it is getting, and what it might be doing there. Check that clocks are enabled, etc.
Before getting in the loop,I sent a msg which can be read bu PC com tool,through USART1. After that,it gets stuck in the loop.But the cursor alsways stay in assembler code.