Hello,
I am very new to LPC2148. And I want to do simple LED blink example program in the beginning. I have written code but I do not know how to dump hex file. Is it done using UART ???? Can any one help please.
Thank you, Ragi
Hi Kopsch,
I have installed MDK. Ant have created hex file. But the problem comes when dumping hex file into the chip through flash magic. It says "Operation Failed. Failed to autobaud - step 1." I am stuck here.
I assume that you are using Flash Magic, right? Please compare the jumper J14: J14 - UART#0 and ISP "ALL ON" (4 jumpers all together)
you may also try to lower the baud rate. If the problem persists contact the Flash Magic Support: http://www.flashmagictool.com/