Hi everyone,
I am using a LM3S5951 controllers for one of my projects in which I need to implement a host side driver for Dot Matrix printer .
I am done with enumeration of the printer, but now I would like to know how can I send data to printers using bulk transfers. I am using the Stellaries USB Library for the same where I found some host side codes for keyboard and pendrive. I would like to know, how to go about this.
Regards
Dhanush
Did you trace the USB traffic of the "genuine" PC driver for the printer? You can trace it with any free USB sniffer, like http://freeusbanalyzer.com/ sourceforge.net/.../ etc.
The "genuine" PC driver should regularly poll the printer status. It may apply bulk IN endpoint or any vendor-specific request other than GET_PORT_STATUS.
Tsuneo
Hi,
I want to implement a USB module as V drive for pendrive where I can get commands through uart such as make directory ,open file etc and then dump the file onto pendrive. I am aware of how USB works, I want to know the feasibility of this project and a starting guide to how can it be achieved.
Regards Sanket
I am using a TM4c123 series controllers with 1 USB host port. Now I am using the same port using the a USB switch to use the keyboard and pendrive. But i want to use them both without switching. I guess this is possible if a USB HUB controller with 2 or 3 downstream ports is available. So how should go about it, are there any controllers which such capabilities available.
Sanket