Hi sir,
T1=NON-SEQ
T2=BUSY
T3=SEQ
T4=SEQ
T5= SEQ
This is for WRITE operation:
i am using a BUSY state for T2. Then my WAIT state for till T3. I have read from the forum if WAIT state u are using a BUSY transfer, you can change next clock on the valid transfer.
If i change the HTRANS to the valid transfer my T1 data will be maintained for till T3 clock. Then what about the BUSY transfer.
This same as applicable for READ operation.And this is only for WAIT STATE.
Regards
Rajaraman R
Thank You Collin for your answer.
I still have a doubt that at T2 i am sending busy from master to slave in my HTARNS then how come my slave can send me HREADY=LOW at same instance of time i.e T2.
Slave might get this acknowledgement at next rising edge of clock which is T3,so i guess at T3 HREADY should go low,But at T2 its getting low.
So,is there any connection between HTRANS and HREADY.
Waiting for your response.
Thanks in advance.
MUKUL.P