I am new to ARM Cortex 4 and to ADSP-CM403F. I worked with AVR stuff and was able using SD cards with SPI, AVR-GCC. I am working on a schematic for the 120pin ADSP-CM403F chip. To be able to code for MicroSD I will have to connect the right pins of the card to the CPU. Unfortunately I did not find an example yet to see if its possible using 4 data lines as SDIO offers. In the data sheet Rev. A november 2015 there are signals like SPI clock, SPI data 2, SPI data 3. I cannot see SPI data 0 or data 1.
Can anybody please give me a hint where to find an example how to add a MicroSD card (and also a QSPI flash, SRAM) to this chip including a simple C example code? Thank you very much !
That's what Development Kits are for!
Never go straight to a PCB without first having got up to speed, and proved your concepts, on a Dev Kit.
"That's what Development Kits are for!"I know.
"Never go straight to a PCB without first having got up to speed, and proved your concepts, on a Dev Kit."
Unfortunately this dev kit is quite expensive and it does not fit to what I want to have.No MicroSD easily to attach for testing. No code for it. No support as it seems.I decided starting using the schematic on the dev kit and try building my schematic from this base. Its not easy for a beginner with this but I try.
It does sound like you'd be better off choosing a different board.
Plenty of others offer 16 (and more bit) ADCs
Many have low-cost dev kits; even with SD Cards on them - but more usually just connected over SPI. Using the 4-bit interface is more advanced.
To be honest, it does sound like you're being a bit over-ambitious here - I think you have a lot of basics to cover before thinking of designing PCBs ...
"It does sound like you'd be better off choosing a different board."If you have a helpful hint here Andy - please tell.
"Plenty of others offer 16 (and more bit) ADCs"I did not find much boards using precise 16bit ADCs like ADI does offer. Many are offering ADCs which are much compromized in accuracy by design. "I think you have a lot of basics to cover before thinking of designing PCBs"I already have a 16bit design using a Atmega2560, AD7714, MAX5717. This worked well. I then switched to Atmega32u4, AD7798, MAX5717. The PCB is there - has to be tested yet. So this ADSP-chip is just the next step. In 1986 I worked with a 10bit AD-converter in a medical device. So all this is not so new for me.
Well, yes - Analog Devices (as the name suggests) are the analogue experts.
So if that's your key requirement, that's going to have to drive your decision.
Dealing with the peripherals on an ARM chip is really no different to dealing with the peripherals on an AVR or any other microcontroller - it's all just about reading & writing registers.
"Dealing with the peripherals on an ARM chip is really no different to dealing with the peripherals on an AVR or any other microcontroller - it's all just about reading & writing registers."Yes. I know how to access a MicroSD card with one channel SPI and AVR. But I did not do yet with a 4 channel SPI. I read the data sheets of the SD card and the data sheet from ADI. But unfortunately its still not clear for me where to connect CMD to. I still search for an example. Hopefully at ADI there will be somebody willing to help here.