I am new to ARM Cortex 4 and to ADSP-CM403F. I worked with AVR stuff and was able using SD cards with SPI, AVR-GCC. I am working on a schematic for the 120pin ADSP-CM403F chip. To be able to code for MicroSD I will have to connect the right pins of the card to the CPU. Unfortunately I did not find an example yet to see if its possible using 4 data lines as SDIO offers. In the data sheet Rev. A november 2015 there are signals like SPI clock, SPI data 2, SPI data 3. I cannot see SPI data 0 or data 1.
Can anybody please give me a hint where to find an example how to add a MicroSD card (and also a QSPI flash, SRAM) to this chip including a simple C example code? Thank you very much !
Well, yes - Analog Devices (as the name suggests) are the analogue experts.
So if that's your key requirement, that's going to have to drive your decision.
Dealing with the peripherals on an ARM chip is really no different to dealing with the peripherals on an AVR or any other microcontroller - it's all just about reading & writing registers.
"Dealing with the peripherals on an ARM chip is really no different to dealing with the peripherals on an AVR or any other microcontroller - it's all just about reading & writing registers."Yes. I know how to access a MicroSD card with one channel SPI and AVR. But I did not do yet with a 4 channel SPI. I read the data sheets of the SD card and the data sheet from ADI. But unfortunately its still not clear for me where to connect CMD to. I still search for an example. Hopefully at ADI there will be somebody willing to help here.