Hi All,
My u-boot is bricked. The flash type is NAND flash. Can I recovery it with DSTREAM? I googled and did not find a document about this.
Thanks.
Tony
Hi Ronan,
Yes, I have a DSTREAM to test. I'm sure my bootloader(u-boot) is broken because wrong code is burnt into the NAND flash. Now the board is not up. In fact, I have a document about how to use TRACE32 to load the image file of bootloader into DDR. Then bring up the board by this bootloader and write the image stored in DDR into the NAND flash. But I don't have TRACE32. I expect DSTREAM can do similar thing.
Hi Tony,
The loadfile command should just load the image directly to memory, assuming it is writable.https://developer.arm.com/docs/101471/1910/arm-debugger-commands/arm-debugger-commands-listed-in-alphabetical-order/loadfileIf you can share the document you have I can be more specific on the differences.Regards,
Ronan
I'm sorry I can not share the document pubic. But I can send to you privately. Is it OK? Thanks a lot.
I recommend using Support -> Open a support case from the above menu to raise an official request with Arm, and we can track it there (please reference this thread).