Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.

We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.

Thank you for your understanding.

  • State Suggested Answer
  • Locked Locked
  • Replies 3 replies
  • Answers 2 answers
  • Subscribers 119 subscribers
  • Views 26100 views
  • Users 0 members are here
Options
Related
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

My DStream does not boot by powercycle

Oscar Huang

My DStream suddently didn't boot after powercycle. All LEDs are off after the power is applied. But it can boot correctly after I press the reset button for a few seconds. I have refreshed the FW in the restoring mode, but the problem is still there. Anybody knows what might be wrong with my DStream? Thanks.

Parents
  • 0 in reply to Stephen Theobald

    Hi, Stephen,

    Yes, I tried factory reset. And it should not be an Ip address issue because I used static IP. It does not boot with both eithernet and usb unplugged. It is an original DSTREAM.

    Because it can boot after I press the reset button for a few seconds, I can still use it. Just a little bit inconvenience. 

    Thanks

    -Oscar

Reply
  • 0 in reply to Stephen Theobald

    Hi, Stephen,

    Yes, I tried factory reset. And it should not be an Ip address issue because I used static IP. It does not boot with both eithernet and usb unplugged. It is an original DSTREAM.

    Because it can boot after I press the reset button for a few seconds, I can still use it. Just a little bit inconvenience. 

    Thanks

    -Oscar

Children
  • 0 Arm Employee Badge in reply to Oscar Huang

    Hi Oscar,

    Thanks for your update.  It does sound like there is a hardware fault with the DSTREAM in its power-on/reset circuitry.  It could probably be repaired via Arm's repair process I mentioned earlier but, if pressing reset is the only a minor inconvenience to you, it probably isn't worth sending the DSTREAM away to be repaired.

    I hope your Arm-based projects continue successfully :)

    Stephen