• State Accepted Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 6 replies
  • Subscribers 350 subscribers
  • Views 5640 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cortex-M3 DesignStart FPGA-Xilinx edition package bitstream incompatible on Arty A7-100T

Shiping

Hi, there

I just downloaded  the "Cortex-M3 DesignStart  FPGA-Xilinx edition packag" and tried to load the bitstream up to Arty A7-100T , but got error

"Incorrect bitstream assigned to device. Bitfile is incompatible for this device"

I think this package maybe created for Arty A7-35T, so it is possible does not work. 

Is there a way to modify it to make it work on Arty A7-100T?

Thanks

Parents
  • 0

    I read somewhere "The pre-built FPGA bitstream only works for Arty boards equipped with an Artix-35T FPGA. For other Arty variants (e.g. the Arty A7-100) the bitstream must be rebuilt." However the page I read didn't say how to do that.. and at this time I have no clue either. I'm in the same boat.. Unless this page is wrong, and it's not something that we can rebuild? but it's the only place with that info i could find anything about it.
    For starters who are just starting I would say yeah.. 35t would of been the best bet.

Reply
  • 0

    I read somewhere "The pre-built FPGA bitstream only works for Arty boards equipped with an Artix-35T FPGA. For other Arty variants (e.g. the Arty A7-100) the bitstream must be rebuilt." However the page I read didn't say how to do that.. and at this time I have no clue either. I'm in the same boat.. Unless this page is wrong, and it's not something that we can rebuild? but it's the only place with that info i could find anything about it.
    For starters who are just starting I would say yeah.. 35t would of been the best bet.

Children