Architectures and Processors forum Cortex-M3 DesignStart FPGA-Xilinx edition package bitstream incompatible on Arty A7-100T

State Accepted Answer
+1 person also asked this people also asked this
Locked Locked
Replies 6 replies
Subscribers 350 subscribers
Views 5643 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cortex-M3 DesignStart FPGA-Xilinx edition package bitstream incompatible on Arty A7-100T

Shiping over 3 years ago

Hi, there

I just downloaded the "Cortex-M3 DesignStart FPGA-Xilinx edition packag" and tried to load the bitstream up to Arty A7-100T , but got error

"Incorrect bitstream assigned to device. Bitfile is incompatible for this device"

I think this package maybe created for Arty A7-35T, so it is possible does not work.

Is there a way to modify it to make it work on Arty A7-100T?

Thanks

Top replies

Parents

0 Shiping over 3 years ago in reply to -Shadow-

I did some changes in Vivado, and able to make a bit stream - but after uploadeds it into Arty A7-100T, no responses at all. I might have made some mistakes, but could not figure out where.
Cancel
Up 0 Down

Cancel

Reply

0 Shiping over 3 years ago in reply to -Shadow-

I did some changes in Vivado, and able to make a bit stream - but after uploadeds it into Arty A7-100T, no responses at all. I might have made some mistakes, but could not figure out where.
Cancel
Up 0 Down

Cancel

Children

No data