This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Why AWLEN signal is optional for master and required for slave in AXI4 protocol ?

Why AWLEN signal is optional for master in AXI4 protocol ? If it is optional for master then how slave will get that signal because it is required for slave ?

Top replies

Colin Campbell over 1 year ago +2 verified

AWLEN is described as "optional" only if the manager design is going to use the "Default" value of all zeroes, so a single transfer. See table A9.3 in the AXI spec, where it states... "The following...

Parents

TillyGough over 1 year ago

This reply was deleted.
Cancel
Cancel

Reply

TillyGough over 1 year ago

This reply was deleted.
Cancel
Cancel

Children

0 Colin Campbell over 1 year ago in reply to TillyGough

AWLEN is the AW channel "length" signal, indicating how many transfers will be in this transaction. It has nothing to do with an address width enable.
Cancel
Up 0 Down

Cancel