This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Remote debug ST Link

Hello,

i use uVision 5.38.0.0 and i want to remote debug on a STLink.

How can i do this?

Parents
  • To set up remote debugging with uVision and an ST-Link, ensure you have the ST-Link Utility installed, connect the ST-Link to your target, configure uVision to use ST-Link as the debug driver, and start the debugging session. Ensure software compatibility for a successful debugging experience.

Reply
  • To set up remote debugging with uVision and an ST-Link, ensure you have the ST-Link Utility installed, connect the ST-Link to your target, configure uVision to use ST-Link as the debug driver, and start the debugging session. Ensure software compatibility for a successful debugging experience.

Children
No data