Support forums

Keil forum I have Keil board, MCBSTM32F400. I want to do SPI communication with it, from a device thru ADC, and pass the data to the controller. Pl mention how can I hook the device to the board?

State Accepted Answer
Locked Locked
Replies 14 replies
Subscribers 21 subscribers
Views 4855 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I have Keil board, MCBSTM32F400. I want to do SPI communication with it, from a device thru ADC, and pass the data to the controller. Pl mention how can I hook the device to the board?

Babuddin Ahmad over 4 years ago

the device could be potentiometer, pressure or temperature transducer, etc.

Top replies

Andy Neil over 4 years ago +1

Babuddin Ahmad said: I want to do SPI communication Do you understand the basics of how SPI works ? It's a very long-established and widely-used thing - so plenty of references available; eg, https...

Parents

0 Andy Neil over 3 years ago in reply to Babuddin Ahmad

Sounds like you really need to start here:

https://www2.keil.com/mdk5/learn

Also see training materials from ST:

https://community.arm.com/developer/tools-software/tools/f/keil-forum/35918/not-able-to-see-variables-in-memory-window/109675#109675
Cancel
Up 0 Down

Cancel

Reply

0 Andy Neil over 3 years ago in reply to Babuddin Ahmad

Sounds like you really need to start here:

https://www2.keil.com/mdk5/learn

Also see training materials from ST:

https://community.arm.com/developer/tools-software/tools/f/keil-forum/35918/not-able-to-see-variables-in-memory-window/109675#109675
Cancel
Up 0 Down

Cancel

Children

No data