This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Are Segger J-Link trace function supported on Cortex-M7 in uVision debugger?

µVISION DEBUGGER: "Trace HW not present" using J-Trace on Cortex-M7 says the JL2CM3.dll JLink/JTrace debugger driver DLL from Segger used in MDK µVision doesn't yet support the trace debug functionality for all Cortex-M7 based target devices.

Now, it's about one year later. So what's the situation now?

I'm designing a PCB, and need to choose which debugger connector should use on my board, J-link or ST-Link, or U-link.

Thanks. 

Parents
  • Not yet. Because I've not found similar report on Segger's site. And I need a product ID to register and post question on that site but I don't own a Segger's product yet. If there still some problems using J-link + Keil, I may need to design my board with a 10-pin SWD connector and stick to ST-Link, but not a JTAG connector. So anyone can give some clues?

Reply
  • Not yet. Because I've not found similar report on Segger's site. And I need a product ID to register and post question on that site but I don't own a Segger's product yet. If there still some problems using J-link + Keil, I may need to design my board with a 10-pin SWD connector and stick to ST-Link, but not a JTAG connector. So anyone can give some clues?

Children