This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

change pack installer to use 205?

Is there any way to make the pack installer to use my selected chip? Every example I make is set up for the stm32f207 and I have the 205 selected. This works for the most part but all the pin names are wrong and it makes thing very difficult.

When I click the copy, it loads my project in to the uvision IDE and says stm32f207. I can pick the right target but the example code is set up for 207 still. To make matters worse the files with pin names (LED_MCBSTM32F200.c) are locked.

Parents
  • All demonstrating STM32F200 example projects are addressed to the STM32F207.
    There currently is no dedicated STM32F205 example project offered by the PackInstaller.
    A customer specific transfer from STM32F207 to STM32F205 requires adaptations with reference to the device specific manual.

Reply
  • All demonstrating STM32F200 example projects are addressed to the STM32F207.
    There currently is no dedicated STM32F205 example project offered by the PackInstaller.
    A customer specific transfer from STM32F207 to STM32F205 requires adaptations with reference to the device specific manual.

Children
No data