This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Transfer a file form computer onto a ST flash memroy

I want to transfer the KEIL generated .hex file from computer's memory via UART onto the internal flash memory of the STM32F4.
Can anyone give me a heads up of where to get started? and what are the important things which needs to be taken care of.

Please note: my UART is working great in both polling and interrupt mode.

thanks,
Sam

Parents

0 Ab p over 8 years ago in reply to Westonsupermare Pier

Hello Sir,

Thank you for your help, I am not from CS. I am an electrical engineer specialized in RTL, wanting to learn embedded systems. So all these terms are new to me.

Thanks for the help
Cancel
Up 0 Down

Cancel

Reply

0 Ab p over 8 years ago in reply to Westonsupermare Pier

Hello Sir,

Thank you for your help, I am not from CS. I am an electrical engineer specialized in RTL, wanting to learn embedded systems. So all these terms are new to me.

Thanks for the help
Cancel
Up 0 Down

Cancel

Children

0 Harsha_NJ over 7 years ago in reply to Ab p

Hi Sam,

Were you successful in transferring a file from PC to STM32 flash? I am trying to do the same using IAP USART protocol and having trouble in configuring the user application that is used to load at a particular address. If you have implemented this, can you share the procedure for configuring the user application that is received using YMODEM.

Thank you,
Harsha
Cancel
Up 0 Down

Cancel