Hi all,
The machine cycle is too slow for me. Is there anyway to input a signal from signal generator into MCU, so I can use it to trigger?
The pin assigns like: sbit dataIN = P1^3; How can I assign an input pin?
Thanks.
So you are just duplicating this post:
http://www.keil.com/forum/62459
Hi,
I'm trying not using "interrupt" but inputting an external signal for trigger. 2 ways for solving the problem. See if anyone can help. Thanks for your time.
So why on earth are you running it so slowly??!!
Clearly, you have no chance of doing anything at 1MHz when the chip is running so slowly!!