This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot find ATmel AT89S51 when creating new project

i just learning keil c ! but i cannot find the device i use ATMEL AT89S51 when starting new project in work group device list what should i do !!??
i am using KEIL 4

Parents
  • I would think that it's quite likely the University then already have lots of documentation - especially since the students are then also likely to do their assignments on similar hardware.

    The other alternative I was thinking about, was that you had bought some package, where you got a board and a specially licensed version of the Keil tools - in which case there would also be some step-by-step getting-started information available.

    Anyway - this site has lots of documentation that you might want to browse through. There is documentation about the IDE. The debugger. How to get started. How to build...

Reply
  • I would think that it's quite likely the University then already have lots of documentation - especially since the students are then also likely to do their assignments on similar hardware.

    The other alternative I was thinking about, was that you had bought some package, where you got a board and a specially licensed version of the Keil tools - in which case there would also be some step-by-step getting-started information available.

    Anyway - this site has lots of documentation that you might want to browse through. There is documentation about the IDE. The debugger. How to get started. How to build...

Children
No data