USB device example for XMC4500 does only run once: Configuration: unchaged from Example-Project + Self-Powered Example: MSC, HID on XM4500 RelaxKit Effect: after reset detection works well and HID or MSC can be accessed. After unpluggin and replugging the device (cont. power) the HID and MSC is not detected anymore by any PC (Win10-64, Win7-64). Is there any sequence available to detect and reconnect the USB device?
It is not resetting of the hardware that is a problem but transfers that were started before USB reset occured are most likely still virutally pending and prevent new transfers from being started.
This has to do with internal RAM structues holding information for transfers not the USB controller itself.