Ulink2 is working fine in Keil4.73 and is able to program TLE9867 device but in Keil5.20 with firmware V2.03 of Ulink2 it is not able to program TLE9879 Infineon MCU. in keil4.73 even with firmware V2.03 of Ulink2 , one can program TLE9867. so conclusion is that Keil5 is not supporting programming of TLE9867 device with Ulink2.
MCU is TLE9867, and I had configure the setting correctly. I am confident about this because even with Keil 5.17 I had notice the same behaviour. as I mention Ulink2 firmware version is V2.03 and it is working with Keil 4 and not with Keil5 I am not the only one got this problem , even my friend got same problem. if you had successful in programming TLE9867 with Ulink2 , pls share the configuration settings
What's the error from MDK v5.x exactly?
Moreover, are you sure you are using an official ULINK2 from keil (not the copied version from ebay)?
Error is "SWD Communication failure" Though my Debugger Serial no is detected correctly
Yes, I purchase a licence version of Ulink2 from Keil. no pirated copy
check the error explanation here http://www.keil.com/support/man/docs/ulink2/ulink2_errors.htm A serial No. showing up only means µVision detect this ULINK2 correctly. "SWD Communication Failure" means your ULINK2 cannot communicate with your target board via SWD port correctly.
btw. where did you buy your ULINK2?
Strange then how come the same debugger is able to program with same PC using with Keil4.17 IDE via SWD port to my target board.