Dear Sir/Madam I have a MCB1700 board and i want to control its LEDs via pc via TCP/ip.in order to do it i used LEDswitch program but i read the help and it suggests to use a specific windows application for control the LEDs via LAN cable and pc.in this case the board is a server and PC is a client. How can i find this windows application ? can i use command prompt window instead of windows application?if yes please help me how to use it. Also please give me some help for configuring my LEDswitch program codes on my board.
Thank you
I set the IPV4 of my laptop to 192.168.2.10 and subnet mask 8.8.8.8 ...
Do you have any idea at all what the subnet mask is used for?
Subnet mask? Isn't that where you enter the IP of one of Google's DNS servers? :p
subnet mask is used for dividing a network to two or more network.in this case i could use 255.255.255.0 .but my issues doesn't solve with it.Do you have another idea?
i could use default number 255.255.255.0.but by this configuration my problem doesn't solve.Do you have any idea for solving the issue?
subnet mask is used for dividing a network to two or more network.
Unfortunately it is clear that you know how the TCP/IP protocol stack uses the information.
Stop playing around with things you don't understand. Set it to what it was before. Otherwise you're likely to not see any success even if you were to find and fix the original problem.
i used original project code (LEDSwitch) and didn't apply any change to it but the problem wasn't solve. How can i send the project code to you for more considering?