Hello all, I have programmed LPC2148 for using USB as secondary boot loader. Code was given by NXP only. It says, when LPC2148 is connected to PC it will open flash memory as mass storage device and flash will be shown in .bin file. Till this everything is fine. To update the firmware one should delete that .bin file and copy new one there. I did the same. Code includes simple LED blink. But on giving power cycle code is not working. If I program BLinkLed code using UART ISP it works correctly.
Document says in USB boot loader's firmware user code start sector should be 2. I did that also.
Do I need to change any settings is my blinkLed firmware so that code will get stored from 2nd sector? or is there any procedure?
Thank you..
This what I done exactly:
; Memory Mapping (when Interrupt Vectors are in RAM) MEMMAP EQU 0xE01FC040 ; Memory Mapping Control IF :DEF:REMAP LDR R0, =MEMMAP IF :DEF:EXTMEM_MODE MOV R1, #3 ELIF :DEF:RAM_MODE MOV R1, #2 ELSE MOV R1, #1 ENDIF STR R1, [R0] ENDIF ;Copy exception vectors to Internal RAM RAM_BASE EQU 0x40000000 IF :DEF: RAM_INTVEC ADR R8, Vectors ; Source LDR R9, =RAM_BASE ; Destination LDMIA R8!, {R0-R7} ; Load Vectors STMIA R9!, {R0-R7} ; Store Vectors LDMIA R8!, {R0-R7} ; Load Handler Addresses STMIA R9!, {R0-R7} ; Store Handler Addresses ENDIF
I have defined those symbols in option->ASM-> defines as REMAP RAM_MODE RAM_INTVEC is that right?
Actually USB boot loader is defined for board MCB2140. I am using same code. They have defined some LEDs to monitor read write and configuration status. I connected the same on my board. Those LEDs glows correctly. Do I need to change anything for my board except LED connections?