I have a project which was completed by another persion by using uvision 3. Recently I plan to add some new fuctionalities in this project. Since I only have uvision 4 on my machine, so, I plan to use uvision 4 to open the project and see if I can complie the project.
Without touching anything of the source and header files, I opened this project using uvison 4. However, when I compiled this project, there was an error message, "_swi_0 multiply defined in hal.o and rtx_config.o".
Is it caused by the toolchain upgrade? could anyone help on this issue?
Thanks a lot!
The hardware platform is LPC 2103 (Arm-7 core based) RTOS: keil MDK RTOS
Louis
Thanks for your quick reply!
Then it's time for standard debugging.
You have enough stack? ----I will double check.
Are the memory regions in the project correct for your processor? ----yes, for both scatter file and flash tool setting, there are same, i.e., on-board rom 0x0-0x8000, and on-board ram: 0x40000000-0x40002000.
You use a boot loader or is your hex file complete for bare-bones execution? ----My understanding is that the startup.s is responsible for loading the real Keil RTOS.
Does the clock settings seem to agree with your processor ----The frequency of the external crystal is 14.7456MHz, which is same as startup.s and the rtx_congig.c settings.