Hello, I want communicate with my lpc2368 by the Ethernet port using an application whose create with visual basic. It is possible ? How ?
Thanks,
Mickael
I don't want to integrate a web server in the lpc2368 but write and read in memory of lpc2368 since my PC using a VB application and communication ethernet.
I look throughout the week on the internet but I found nothing of this subject.
As I said earlier I have already make an ethernet communications between two PCs but I was writing code on two PCs with VB. With the lpc2368 I can't write code in VB. That is why I ask is forum on how I should proceed?
Exactly what did you spend the week searching for? There are a lot of information on this forum, and the NXP forums in case you searched.
1) Get a compiler for the ARM. For example Keil or gcc. Keil is expensive and the evaluation version will not do because of the code-size limitations.
2) Get a TCP/IP stack for the ARM. For example Keil. Or search on this forum (or on the net) for suggestions about available free stacks, or free OS with included stack, for these processors. If you can't afford the Keil compiler, look for free code supported by gcc (I would guess most/all free ARM code does).
3) Collect all sample code you can for the OS/stack and read it at least twice.
4) Write application using 2 and compiled with 1.
5) Load into hardware and test.
6) Test/update repeatedly until it works.
7) Post questions to web forums if you get stuck.