Hi
i want to put a table data at flash (at specific address). How can i save it to the compiled output file? The FLASH.INI file do this? How?
Thanks a lot.
If you are to do in assembly - You can use
LDR PC,abcd_addr
abcd_addr is your jump address. You can hava a section x and define a series of this instruction. Place that section at whatever fixed address you want. This is how I load the Interrupt vector table .
Regards
suvidh
thanks again suvidh.
can you send your example of scatter loading file? there is no examples in keil manual at home page.
You can get more idea about how to do this from this article.
http://www.keil.com/support/docs/3237.htm
Suvidh