After upgrading my Windows 7 installation of Mali to version 2.1 using the installer, multisampling doesn't work anymore for my application beside the program successfully choosing a configuration that supports it. I also get lots of bad allocs. Any ideas?
Hello,.
I will see what I can do. For starters, the Mali Cube Application doesn't seem to have multisampling activated for me.
Btw I have now a 14.501.1003.0 Catalyst Driver version. Problem persists.
Tested on a Nvidia card. Same.
Hello,
At this point we suspect an issue in the Emulator codebase with multisampling support not fully supported by an EGL implementation. So we will assign an internal ticket to investigate this problem and will get back to this post with and answer where we are with this.
Also, to confirm we look to the same problem, could you give us view which set set of EGL attributes you are using to choose your config?
Cheers
Adam
Hello again,
I confirm that there is an issue with the emulator using multisampled EGL config at the moment.
We've decided to prepare a bugfix release that will address the problem and it should be available for download shortly from now.
Thanks for help in spotting that.
Cheers,
...and here we are.
The 2.1.1 version has been released and published on the malideveloper.arm.com site today, and it contains a fix for the indicated problem.
Regards,
I can confirm that multisampling in the cube application now works for me as well. I will test it with my full application in the following days.
Thanks for your efforts so far.
Regards