• State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 137 subscribers
  • Views 11080 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Mali Core Unit Utilization graph in Streamline no longer including up to a hundred%

chawalinsan

Hi,

I consider I'm misinterpreting the counter templates in the Mali Core Unit Utilization on my S10e (Mali-G76), so just need a few explanation. My preliminary assumption was that the counters might upload up to 100%. However, as you can see beneath, they are including up to a long way greater than that. Is this by hook or by crook associated with the truth that the G-seventy six has three execution engines (from what I can collect) but only 1x Texture, L/S and Varying gadgets?

Parents
  • 0

    Hi , 

    Can you share a picture of the problem, or the APC data file? Which version of the tools are you using?

    Series in the utilization chart should individually have a maximum value of 100%. However as the units execute in parallel they will sum to something much higher than 100% under heavy load - each unit can be fully utilized at the same time as other units.

    Kind regards, 
    Pete

Reply
  • 0

    Hi , 

    Can you share a picture of the problem, or the APC data file? Which version of the tools are you using?

    Series in the utilization chart should individually have a maximum value of 100%. However as the units execute in parallel they will sum to something much higher than 100% under heavy load - each unit can be fully utilized at the same time as other units.

    Kind regards, 
    Pete

Children
No data