how to configure a I2C in MCB1700 with LPC1758?
I have a MCB1700 board with LPC1758, I am trying to use the I2C on it as a master to run a ultrasonic sensor srf08.
How should I configure the I2C setting on the LPC1758?
I was away from computers for a while.
Have you tried the software you wrote? That would be the best way to see if it works or not...
You can also add an oscilloscope on the line and see what is being sent.
I have used I²C a lot but I haven't used this NXP I²C module or that driver.