• Locked Locked
  • Replies 2 replies
  • Subscribers 20 subscribers
  • Views 3832 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

"Bytestreamer failed" error when booting V2S-A53x2 on VersatileExpress

Jianle Qiu

Hi There,

We have V2S-A53x2 tile on VersatileExpress board. It failed to boot and we got the message below. It is appreciated if any guidance. Thanks!

Programming NAND from \SITE2\HBI0247C\SMMA53\a53_b00.bit

Percentage complete:100% (0 bad pages)

Starting NAND bytestreamer...

ERROR: Bytestreamer failed.

Verifying NAND from \SITE2\HBI0247C\SMMA53\a53_b00.bit

Percentage complete:100%

ERROR: FPGA failed to configure but NAND verify passed.

Please update the bit file image as it could be corrupted

or set UPDATE: TRUE in config.txt to re-format the NAND

  1. memory.

ERROR: DB2.0 DCC 0 FPGA 0 SPI configuration failed.

 

Best Regards,

Jianle

 

Parents

  • Hi Jianle,

    This is probably not an issue of wider interest to connected community users.

    I believe you have raised a case with support with regards to this issue, in which case we will help you through our support interface.

    If you have not already raised a support case then please let me know!

    kind regards

    Michele

Reply

  • Hi Jianle,

    This is probably not an issue of wider interest to connected community users.

    I believe you have raised a case with support with regards to this issue, in which case we will help you through our support interface.

    If you have not already raised a support case then please let me know!

    kind regards

    Michele

Children