I'm using Linaro Release 15.12 LSK (without OP-TEE) + OpenEmbedded Minimal Filesystem on Juno-r1 Board.
I'm trying to put the Juno board into the Sleep-state referring to ARM Versatile Express Juno r1 Development Platform Technical Reference Manual.
But it seems to reboot and fall into the error state, even if I push the Soft Reset button briefly.
Does anyone know how to put the Juno board into the Sleep-state ?
Thank you for your help.
------------Moderator edit: As of release 16.05 you can follow the instructions here:https://community.arm.com/dev-platforms/w/docs/239/system-suspend-to-ram------------
Hi Sudeep,
Thanks for your prompt reply.
I tried with defconfig on Linaro 16.05 latest and the issue did not happen as well as v4.7-rc4.
There is much difference between defconfig and linaro config, so I am trying to check them.
Regards
Hi,
I reported that the issue surfaces when I try to suspend & resume twice continuously with Linaro 16.05 latest above.At that time I used prebuilt binaries (snapshots.linaro.org/.../ : Now not found),but the binaries that built from a source code (fetched by the following commands) does not surface the issue.
# repo init -u https://git.linaro.org/landing-teams/working/arm/manifest -b 16.05 -m pinned-latest.xml # repo sync
Thank you.
Hi Taken,
I am confused. Is the problem solved for you now ?
Regards,
Sudeep
Sorry that I didn't write the conclusion.Yes, the problem was solved.
Thank you so much for all your help.