• State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 23 subscribers
  • Views 3787 views
  • Users 0 members are here
2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem with Timer simulation of TC0 with ATSAME54

Tom059

Hi ,

i just tried out to use the TC0 of ATSAME54 in my application. The 16 and 32 Bit CC0, CC1 registers seem to be only 8 bit usable instead of 16/32 Bit. The status register evaluate correct during program run, but can´t be set correctly during test.

Thanks and best regards

Thomas

Parents
  • 0 in reply to Zhifei Yang

    Hi Zhifei  Yang, i tried every type of initialisation. The display shows 8/16/32 Bit lenght in the data, but only the lowest 8 Bits change in the peripheral display. If i load the data into external variables the results are correct in 8/16/32 Bit values. I also can change the values to longer datatypes by hand, but it displays only the lowest 8 Bits.

Reply
  • 0 in reply to Zhifei Yang

    Hi Zhifei  Yang, i tried every type of initialisation. The display shows 8/16/32 Bit lenght in the data, but only the lowest 8 Bits change in the peripheral display. If i load the data into external variables the results are correct in 8/16/32 Bit values. I also can change the values to longer datatypes by hand, but it displays only the lowest 8 Bits.

Children
No data