This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Interfacing GSM module with STM32F0

I am interfacing a gsm module with stm32f0 board. I am new to this section. I want to send and receive AT command to gsm module and receive its response via UART. Sending section is completed but problem with receiving part. please get me out this thing.

Top replies

Jerome Decamps - 杜尚杰 over 4 years ago in reply to Oliver Beirne +2

Hi Oliver, I mean you can transfert it in : Arm Development Platforms forum
NIshi_kant over 4 years ago in reply to Oliver Beirne +2

Thank you Oliver
Jerome Decamps - 杜尚杰 over 4 years ago +1 verified

Hi What I know about your problem is not related to the hardware, but to the management of the UART. To operate correctly you must know the size of the stream transmitted via the UART, otherwise the...

Parents

+1 NIshi_kant over 4 years ago in reply to Jerome Decamps - 杜尚杰

Thank you Jerome
Cancel
Up +1 Down

Cancel

Reply

+1 NIshi_kant over 4 years ago in reply to Jerome Decamps - 杜尚杰

Thank you Jerome
Cancel
Up +1 Down

Cancel

Children

No data