• State Accepted Answer
  • Locked Locked
  • Replies 7 replies
  • Subscribers 22 subscribers
  • Views 11054 views
  • Users 0 members are here
Options
Related
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

GCC and GDB for native compiling and debugging

Lumin

Hello,

I 've a module with a Cortex-M4 Vybrid VF61 processor and an installed linux.

The installed linux does not provide gcc and gdb for native compiling and debugging.

Please, can anybody tell me, where I can download a prebuilt gcc and a prebuilt gdb for native compiling and debugging ?

Best regards

Parents
  • 0

    Dear Lumin,

    Please try here: https://developer.arm.com/open-source/gnu-toolchain/gnu-rm

    You will find here embedded toolchains which allow you to cross compile your programs to e.g. Cortex-M4 boards.

    Running natively gcc and gdb on Cortex-M4 board might be tricky as not many support e.g. Linux as its host operating system.

    For embedded systems you would rather use JTAG interface (or similar) to debug your embedded / bare-metal host using GDB. GDB would be running on your PC/Mac and via JTAG you would connect to your board to flash firmware and debug.

    /Przemek

Reply
  • 0

    Dear Lumin,

    Please try here: https://developer.arm.com/open-source/gnu-toolchain/gnu-rm

    You will find here embedded toolchains which allow you to cross compile your programs to e.g. Cortex-M4 boards.

    Running natively gcc and gdb on Cortex-M4 board might be tricky as not many support e.g. Linux as its host operating system.

    For embedded systems you would rather use JTAG interface (or similar) to debug your embedded / bare-metal host using GDB. GDB would be running on your PC/Mac and via JTAG you would connect to your board to flash firmware and debug.

    /Przemek

Children
No data