This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem running post install script

I have installed DS-5 v5.28.0 on Ubuntu 16.04 LTS.

The post install stage reported the following problem:

Post install stage provides the following functions:
- Installation of USB drivers for RealView ICE and DSTREAM hardware units
- Set default toolkit selection

Please answer with one of: 'yes/y' or 'no/n'
Run post install setup scripts? [default: yes] yes

--- Running post install setup scripts

No default toolkit set

As far as I can tell, the USB drivers for DStream have not been installed.

How do I set the default toolkit to enable the post install setup to complete successfully?

Thanks.

Parents Reply Children
  • Thanks Lukas.

    I have re-run the script and get the same output.

    However, I have now realised that the USB drivers have in fact been installed correctly. I'm still confused why the script reports "No default toolkit set" - I have used the ARM license manager to install a license and select a toolkit, but the script still reports the same thing.

    Could it be that the script is just reporting that it hasn't set the toolkit and isn't actually reporting an error?

  • Yes, the message is purely informational to indicate that no toolkit has been set in the current environment.