This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New SoC Bring up in DS-5

I have seen this link " DS-5 Development Studio | SoC Bring-Up Using the Platform Configuration Editor PCE – ARM Developer "  for new SoC Bring up in DS-5 was using DSTREAM.

Can I use RealView ICE instead of DSTREAM for new SoC bring up.

Kindly guide me .

Parents
  • Hi Shravan,

    It looks like a similar problem. Device 0 is obviously an ARM DAP, so that's good - we know the IR length on the DAP is 4 bits, so it's obviously wrong. What's coming out there is that the other TAP (0x03727093) is not responding correctly.

    Just from the chain I can tell this is a Xilinx Zynq. Is there any reason you're not using the bundled configuration? You should be able to just connect to it without creating your own platform.

    If that isn't working for you, you can simply add "ARMCS-DP" and then an "UNKNOWN_6". If you right click the ARMCS-DP it will give you an option to enumerate APs and detect devices from that point (without doing the blind interrogation step).

    Ta,

    Matt

Reply
  • Hi Shravan,

    It looks like a similar problem. Device 0 is obviously an ARM DAP, so that's good - we know the IR length on the DAP is 4 bits, so it's obviously wrong. What's coming out there is that the other TAP (0x03727093) is not responding correctly.

    Just from the chain I can tell this is a Xilinx Zynq. Is there any reason you're not using the bundled configuration? You should be able to just connect to it without creating your own platform.

    If that isn't working for you, you can simply add "ARMCS-DP" and then an "UNKNOWN_6". If you right click the ARMCS-DP it will give you an option to enumerate APs and detect devices from that point (without doing the blind interrogation step).

    Ta,

    Matt

Children
No data