Arm Development Studio forum how to integrate Ulinkplus in arm ds

State Accepted Answer
Locked Locked
Replies 4 replies
Answers 1 answer
Subscribers 122 subscribers
Views 27820 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

how to integrate Ulinkplus in arm ds

Deepak over 5 years ago

Dear All,

I need to debug my application on arm ds with ulinkplus, but in connection type drop-down menu ulinkplus is not available.

Is there any document that I can refer to?

Please help me to get ulinkplus working with arm ds.

Top replies

Parents

+1 Ronan Synnott over 5 years ago in reply to Andy Neil

Hello, to qualify this statement, you can program the Ulinkplus firmware to be a CMSIS-DAP interface, which can then connect to Arm DS (as a CMSIS-DAP interface) - however none of the special functionality of ulinkplus (power measurement, testpoints, etc) are supported.

http://www.keil.com/support/man/docs/ulinkplus/ulinkplus_su_fw_update.htm

Regards,

Ronan
Cancel
Up +2 Down

Cancel

Reply

+1 Ronan Synnott over 5 years ago in reply to Andy Neil

Hello, to qualify this statement, you can program the Ulinkplus firmware to be a CMSIS-DAP interface, which can then connect to Arm DS (as a CMSIS-DAP interface) - however none of the special functionality of ulinkplus (power measurement, testpoints, etc) are supported.

http://www.keil.com/support/man/docs/ulinkplus/ulinkplus_su_fw_update.htm

Regards,

Ronan
Cancel
Up +2 Down

Cancel

Children

No data