This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Some questions of AXI

Note: This was originally posted on 14th November 2011 at http://forums.arm.com

>>In AMBA4 AXI rev 2.0, in chapter 4.1 About addressing options:
>>Burst must not cross 4KB boundaries to prevent them from crossing boundaries between slaves and to limit the size of the address incrementer required within slaves.
Is it mean there use 20 bits to decode which slave is selected?

>>In chapter 9.2 Write strobes:
>>The write strobe signals, WSTRB, enable sparse data transfer on the write data bus.
I don't know what is this sentence mean. anybody can explanation detail, thanks!!

Parents

tony huang over 12 years ago

Note: This was originally posted on 15th November 2011 at http://forums.arm.com

Hello JD,
thanks for your reply, it's really help me! thanks again.
Cancel
Vote up 0 Vote down

Cancel

Reply

tony huang over 12 years ago

Note: This was originally posted on 15th November 2011 at http://forums.arm.com

Hello JD,
thanks for your reply, it's really help me! thanks again.
Cancel
Vote up 0 Vote down

Cancel

Children

No data