Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Has anyone used nic400 to configure outstanding capabilities? My current configuration: Master configures issue capability 16, slave receives 16,
but switch0 stops after sending 3 (ASIB's AREADY is pulled down), and has to wait until the end of one write data before sending it again, and the
follow-up is to write a data, the switch sends an address to the slave. There is no outstanding function at all. Can anyone give me some advice？
below is config info：
only send from mater0 to slave0
Hi there, I have moved your question to the Architectures and Processors forum. Many thanks.