We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Has anyone used nic400 to configure outstanding capabilities? My current configuration: Master configures issue capability 16, slave receives 16,
but switch0 stops after sending 3 (ASIB's AREADY is pulled down), and has to wait until the end of one write data before sending it again, and the
follow-up is to write a data, the switch sends an address to the slave. There is no outstanding function at all. Can anyone give me some advice？
below is config info：
only send from mater0 to slave0
Hello rainbowbirds_aes
Apologies for the delay in responding to your question. Are you still looking for help with this? If so, please take a look at https://community.arm.com/support-forums/ and let me know which forum I can move this question to, in order to help you find the answer.
Many thanks
Oli
Arm Community team