Hello. I am trying to operate FMC interface in STM32H743 processor. Configuration was done using STM32cubeMX.
In code, after configuration, just have a loop with reading once per second.
HAL_SRAM_Read_8b(&hsram1, (uint32_t*)0x60000000, (uint8_t*) buf1, (uint32_t) 1);
All lines remain idle high . No sign of trying to read something.
Attached link to drive IOC file from STM32cubeMX.
Drive with configuration file
Is there some additional configuration or initialization shall be done?
Thanks
Isn't this a question for ST - not ARM.