Hi,
I'm trying to make a STM32L100RC work as a CDC device as shown on this website :
https://damogranlabs.com/2018/02/stm32-usb-cdc/
Nevertheless, it didn't work for me, even when I used the exact same file shared on the website. The USB is always detected as "STlink Dongle" by the PC.
Do you think it could be related to the cable I'm using to connect the mcu to the PC?
I already upgraded the ST-Link firmware through this link STSW-LINK009 and the ST-Link Utility
Thank you in advance,
Jay
Here's the link to the board: https://www.eng.auburn.edu/~nelsovp/courses/elec3040_3050/ARM_Keil%20Documents/STM32L100Discovery_UserManual.pdf
I've seen that the ST-link can be used as com port.
EGGA JIAR said:I've seen that the ST-link can be used as com port.
But that's not what the article you quoted is talking about?
That board, and the ST-Link, are a ST products - nothing to do with Keil or ARM - so you need to go to ST for support with then:
https://community.st.com/s/