I have a TIVA launchpad TM4C123GHPM. I was able to Debug the board/code with IAR and CCS. With uVision, when i go to Debug tab, I do not see the Stellaris ICDI option from the dropdown to select the ICDI. I am using uVision 5. I do see CMSIS-DAP Debugger option but no Stellaris ICDI. Am i missing anything during the uVision installation? Please advise.
Hi Christopher,
I have downloaded and run the exe file linked in the support docs 4196.htm. However I cannot see the Stellaris ICDI under the debug TAb in the options for Target 1 dialog.
Are there additional steps required after running the exe file?
Regards
Peter
Hi Peter,
there are no additional steps necessary. Just run this installer which is attached to our knowledgebase article www.keil.com/support/docs/4196.htm and specify the correct MDK installation path.
This installer copies the uVision driver (lmidk-agdi.dll) for this debug interface into the BIN folder and also adds it to the Tools.ini file. I tested it with a genuine MDK 5.29 installation and after that I was able to select the 'Stellaris ICDI' debugger in the 'Options for Target - Debug' dialog.
Hans
Hi Hans,
I have the same issue as Peter in that the 'stellaris ICDI' debugger doesn't show up in the debug tools even after running the add-on installer.
Following your hints above, I manually copied the lmidk-agdi.dll (from a keil v4 installation) into the BIN folder, and edited the Tools.ini to include the line, but still can't get it working. What else could be the issue?
PS:I've also installed the legacy support pack but that didn't help either. I'm using the Tiva C launchpad board from TI.
Thanks
Ah, I've figured it out. I hadn't changed the installation directory! Should've been D:\Keil_v5 instead of C:\Keil_v5.
Thanks!
"specify the correct MDK installation path." .... Can ypu tell us how to do that ? I did not see any mention of it on the support/download page. Thank you.
The recommended path is i.e. C:\Keil_V536 (Keil MDK 5.36 is the latest release available today)
The installation is introduced i.e. at our Video Tutorial "Setup Arm Keil MDK" : http://www2.keil.com/video
The server that this video is on, is painfully slow. It hangs up every couple of seconds of playback. I don't get that anywhere else on the internet so perhaps you can tell your IT people to look in on the server stats.
Sorry I put my installation at a different location, so I have to update the path. I installed that patch but at no time during it's execution was i ever prompted to include this path. It just finished and that was it. i went back to the Debug list and there is still no mention of Stellaris. I'll see if I can get through the video .... I guess, but my question is now : Where do I go to update the path that my toolchain is on ?