I have a TIVA launchpad TM4C123GHPM. I was able to Debug the board/code with IAR and CCS. With uVision, when i go to Debug tab, I do not see the Stellaris ICDI option from the dropdown to select the ICDI. I am using uVision 5. I do see CMSIS-DAP Debugger option but no Stellaris ICDI. Am i missing anything during the uVision installation? Please advise.
You can use an external debug adapter to connect to the SWD interface, as mentioned in below link:
http://www.ti.com/lit/ug/spmu296/spmu296.pdf
I think this is a possibility, not a complete description about how to implement it: An external debug interface can be connected for Serial Wire Debug (SWD) and SWO (trace). Table 2-7 shows the pins used for JTAG and SWD. These signals are also mapped out to easily accessible breakout pads and headers on the board.
So, it's "fun". Texas directs us to keil and keil directs us to Texas. Not very helpful