AHB amba 5 lite - waited write transfer

Hello,

i didnt find at spec any note about the waited write transfer.

for example 

T1 : NONSEQ + write transfer  + HREADY is high

T2: HREADY dropped + HTRANS is idle - HWDATA ?

does the HWDATA have to be the right data or it can be any junk ? and only when the HREADY will rise again the HWDATA have to be the correct one ?

thank Michael

Parents Reply Children
  • The AHB protocol works in a pipelined manner, so in T2 you have an IDLE transfer in its address phase, but also the earlier NONSEQ transfer in its data phase, and during the data phase of a write transfer HWDATA must be driven constantly (even when HREADY is low).

    So the fact that HTRANS is IDLE in T2 isn't really relevant to what HWDATA is doing in T2.