Support forums

Arm Development Studio forum DS-5 Gator Module Customization

Locked Locked
Replies 8 replies
Subscribers 120 subscribers
Views 4367 views
Users 0 members are here

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DS-5 Gator Module Customization

David Bercovitz over 11 years ago

Note: This was originally posted on 30th November 2011 at http://forums.arm.com

Hello,
I have the default DS-5 and Streamline setup working fine using a Pandaboard. I have the gator.ko 5.7 source code and I'm trying to add some new traces to gator.ko. Using the mmaped exemple, I'm returning always the same 'int' value=300 from my function which I trace through a "printk" too. The printk shows the value is good and always equal to 300. However, going to the DS-5 Eclipse IDE, the Streamline interface shows some strange values in the range of 145 to 427 when zooming to the 1ms on the graphical Timeline view. It looks like the values displayed are not constant but around my original 300 value. Can anyone explain how this should be working to display a constant value in the IDE?
Thanks a lot,
David.

Parents

David Bercovitz over 11 years ago

Note: This was originally posted on 20th February 2012 at http://forums.arm.com

Hi Pawell,

Unfortunately I have the same issue although I always return a constant.
I think the problem is somewhere else. Are you testing on Pandaboard / OMAP4 platform?

Thanks
David
Cancel
Vote up 0 Vote down

Cancel

Reply

David Bercovitz over 11 years ago

Note: This was originally posted on 20th February 2012 at http://forums.arm.com

Hi Pawell,

Unfortunately I have the same issue although I always return a constant.
I think the problem is somewhere else. Are you testing on Pandaboard / OMAP4 platform?

Thanks
David
Cancel
Vote up 0 Vote down

Cancel

Children

No data